Overview
How one eight-pad grid serves seven modes, which mode to choose, and what a deck needs before the pads work.
Every deck has a grid of eight performance pads, and the mode tabs directly above it decide what those pads do. The pads are not fixed-function buttons. The selected mode turns the same eight squares into hot cues, loop rolls, beat jumps, samples, stem controls, or pitch controls. Each deck keeps its own selected mode, so two decks can show different modes at the same time.
The grid
- Eight pads in two rows: pads 1–4 on top, pads 5–8 on the bottom.
- Mode tabs sit directly above the grid. Selecting a tab switches what the pads do.
- Cue is the default mode when a deck starts.
- The pads need a track loaded on that deck. Until then they are disabled, though you can still change the selected mode.
- Stems pads additionally need stems for the loaded track, either an NI Stem file or generated first.
Choosing a mode
| Mode | What the pads do | Reach for it when |
|---|---|---|
| Cue | Hot cues: save, jump to, and delete marker points | You want to jump back to a saved position |
| Roll | Temporary loops that play while the pad is held | You want a loop that ends the moment you let go |
| Jump | Move the playhead forward or back by a set number of beats | You want to skip an intro or pull a drifted track back |
| Sample | Trigger samples from a bank of up to eight | You want a vocal stab, drum hit, or acapella over the track |
| Stems | Mute or isolate the drums, bass, other, and vocals layers | You want to drop one layer or hear one layer alone |
| Keys | Play the root hot cue at a chosen pitch | You want a vocal or stab in key without editing the track |
| Shift | Shift the pitch of the whole deck up or down | You want to bend a track into the key of what is next |
Two pad modes found in other DJ software are not available yet: Slicer and Stems FX.
Modifier keys
Several pad actions use Shift while pressing a pad: deleting hot cues and samples, and switching semitone pages in Keys and Shift. Hold Shift as you press, exactly as you would with a controller’s shift bank.
Beat-based modes
Roll and Jump move the playhead relative to the track’s beat grid, so both need the track BPM to have been analysed. With Quantize enabled, a Roll starts and a Jump lands on the beat instead of wherever the playhead happened to be. Beat grid covers that analysis.
What is not a pad mode
Roll loops are held and temporary. Latching loops that you set, save per track, and recall sit in the deck’s own Loop tab: Loops.
Shift pads transpose the deck in semitones, so they meet the deck’s key lock and tempo controls. Tempo and sync covers key lock and the pitch display; Decks is the map of the whole deck card.
In this section
| Page | What it covers |
|---|---|
| Hot Cues | Saving, jumping, deleting, and where cues are stored |
| Loop Roll | Hold lengths, stacking pads, and release behaviour |
| Beat Jump | Jump sizes and landing on the beat |
| Sampler | Assigning, banks, play modes, and clearing |
| Stems | The mute and isolate rows, and the state while stems are missing |
| Keyboard | Root cue, held playback, and the four semitone pages |
| Key Shift | Latching an offset, five pages, and the utility pads |