Skip to content

Sampler

Assign tracks to the eight sampler pads, manage banks, choose a play mode, and clear a pad.

Select the Sample tab and the eight pads trigger short pieces of audio from the deck’s sampler, alongside the track that is playing. The audio can be a vocal stab, a drum hit, or an acapella.

Before you start

  • A track is loaded on the deck. With no track the pads are disabled: Overview.
  • The sample you want is in the library, ready to drag.

Assign a sample

  1. Select the Sample tab.
  2. Drag a track from the library onto a pad.
  3. Drag another track onto an assigned pad to replace the sample.

Banks

Samples are organised in banks of eight slots. The settings button lists the available banks, and the active bank’s name is shown in the pads header.

That menu also opens the bank settings:

  • Name: rename the bank.
  • Play mode: how the pads in this bank trigger.
Play mode Behaviour
Oneshot Starts a single, non-looping play that runs to the end of the sample; release does not stop it
Hold Plays while the pad is held and stops on release
Loop Repeats while the pad is held and stops on release
Default Follows Sampler play mode in Settings → Deck, which is Oneshot unless you change it

Check the result

  • An assigned pad shows the sample’s name and length.
  • The pads header shows the active bank’s name.

Clear a sample

Hold Shift while pressing an assigned pad to clear the sample, leaving the pad empty.

If a pad does not fire

  • The pad is empty: drag a library track onto it.
  • The sample stops on release: the bank is in Hold or Loop. A bank on Default follows the Sampler play mode in Settings → Deck, which can also be Hold or Loop. Set the bank’s play mode to Oneshot if it should run to the end.